|
Author
|
Message
|
|---|
Anon
Deleted
Posts :
Location :
Status : Offline
|
ford to bedford clutch
Could anyone please tellme what clutch I need this convertion,do I need a full clutch kit or do I use the bedford pressure plate ? I hope this is ok,Cheers+Beers Jim.
----------------------
|
 Tue 20 Nov 2012 @ 15:11
|    |
Anon
Deleted
Posts :
Location :
Status : Offline
|
Hi Jim, if your using a bedford flywheel you will need a bedford pressure plate.
Dave
----------------------
|
Wed 21 Nov 2012 @ 07:38
| |
Anon
Deleted
Posts :
Location :
Status : Offline
|
clutch
Hi Dave,thanks for the info.Sorry my message was so garbeld,I was having a bad day.So if I keep the same fiywheel and pressure plate and change the centre plate do I need to change the thrust bearing?Ihope that this will be the last question for a bit.Cheers+Beers,Jim.
----------------------
|
Wed 21 Nov 2012 @ 20:50
| |
Anon
Deleted
Posts :
Location :
Status : Offline
|
Hi Jim I take it your using a ford box so the bedford release bearing probably wont fit in that case you will have to use the ford one but make sure the diameter is the same.I am saying this because someone had put a slightly smaller diameter one on my camper and it broke some fingers on the pressure plate.
Dave.
----------------------
|
Thu 22 Nov 2012 @ 07:48
| |
Anon
Deleted
Posts :
Location :
Status : Offline
|
gearbox
Hi dave.Thanks for the reply.I understand what you mean about the thrust bearing.Would a ford fiy wheel need much altering to fit a sloper engine?It's just a thought,might make life easier.Cheers+Beers Jim.
----------------------
|
Thu 22 Nov 2012 @ 14:34
| |
Anon
Deleted
Posts :
Location :
Status : Offline
|
Hi Jim, I dont think so , depends on cranshaft flange fitting, I personally would use the bedford pressure plate and the ford spinner plate making sure the ford release bearing is the same diameteras the bedfod.
Dave
----------------------
|
Fri 23 Nov 2012 @ 07:28
| |
Anon
Deleted
Posts :
Location :
Status : Offline
|
gearbox
HiDave,I know that this will sound silly but I now undestand what you mean.See I said I am a bit slow on the uptake.But when I get there BAM.I do look forward to meeting you oneday.Thanks for the info .Cheers+Beers,Jim
----------------------
|
Fri 23 Nov 2012 @ 20:32
| |
Anon
Deleted
Posts :
Location :
Status : Offline
|
clutch mod
Hi all,has anyone tried to fit a Ford 9 inch centre plate in to a Bedford pressure plate? I ask as looking at the diamentions it may be fesable.Ilook forward to your comments and surjestions.Cheers+Beers Jim.
----------------------
|
Wed 28 Nov 2012 @ 20:54
| |
|
Time in GMT
|
New posts since your last visit
Old post